American Energy Systems MF3522 Door - Manual

F:\AESBusinessSystems\AES Technical\Piece part instructions\MF3522 1218 Door Assembly.doc
1218 Door Assembly Instructions
Part #MF3522, MF3515, CF13, CF3519, MF3522-B, MF3519,
MF3519-BRNKL
For all Countryside, 6500 & 7500 units
• Turn off unit
• Remove existing door (may need to use rubber mallet to tap
upwards to remove)
• insert door onto the 2 hinge pins
NOTE: The top and bottom hinge pins can be moved in or out to adjust the amount of pressure on
the rope gasket when the door is closed. They also balance the gasket pressure between the left and
right sides. The top hinge pin can be moved left or right to adjust the centering of the rope gasket
on the door frame
The following 4 tests check the door alignment and pressure
• The 1 st test described in the photo below, gives a visual
indication that the pressure will be fairly even across the door.
This is a approximate measurement but will give you a quick
idea if the hinge pins need to be adjusted.
…when the end
of the latch bolt
is slightly past
the edge of the
right frame.
As you close the door,
the gasket on the hinge
side should start to
compress against the
left frame...