American Energy Systems BF-9210 - Manual (Page 2)

F:\AESBusinessSystems\AES Technical\Piece part instructions\BBF-9200 BBF Shroud Installation
Instructions.doc
• Remove the backing from the roll of fiberglass insulation included in your trim panel box. Stick the
insulation to the backside of the trim panels around the perimeter. This insulation will seal up against the
face of the fireplace brick. For stone or irregular surfaces you may have to obtain additional fiberglass
to fill the voids from you local building supply store. Very irregular surfaces with large voids may
require masonry fill.
• Install the black or brass trim around the outside edge of the panels. Ensure the 2-angle brackets
provided are installed on these black or brass trim. If the bottom of the side trim wants to pull away
from the trim panels a small amount of silicone may be required on the backside of the trim to hold it in
place during installation.
Back of BBF unit