American Sanders B-2+ Edger - Manual (Page 7)

Clarke ® American Sanders Operator's Manual (CE) - American B-2 - 7 -
MACHINE SET-UP
To prepare the machine for use, follow this procedure:
1. Familiarize yourself with the machine. Read all dan-
ger, warning and caution statements and the Owner's
Manual. If operator is unable to read English, have
the manual explained before operating.
2. To install or replace abrasive, turn the machine
upside down and let it rest on the motor cover. With
the wrench supplied, remove the screw and abrasive
retainer. Hold pad to prevent it from rotating and turn
wrench. See figure 3.
3. Center abrasive on pad and install the abrasive re-
tainer and screw. Tighten screw.
4. Return machine to upright position.
WARNING: Serious injury could occur when attempt-
ing to replace abrasive while machine is
connected to power supply. Always dis-
connect power before installing abrasive.
CAUTION: Gearbox damage could result from ma-
chine resting upside down for extended
periods of time. Lubricant may drain
from gearbox. Always return machine to
upright position after installing abrasive.
Figure 3