Angelcare AC601 - Manual (Page 8)

STEP 4 - TURNING ON YOUR MONITOR
3
1) Slide ON Parent Unit Volume/Power
button.
2) Push Nursery Unit Power ON/OFF
button for 2 seconds.
3) Set both Units on the same channel
(A, B or C). Must always be on
matching channels.
4) Select your detection mode .
Sound and Movement
Allows you to detect baby’s sounds and
movements as well as hear a TIC sound
at each movement.
Tic OFF
Allows you to detect the baby’s sounds
and movements without the TIC sound.
Sound Only
Allows you to detect ONLY the baby’s
sounds. Movement detection will
be deactivated.
DETECTION MODE FEATURES
1
4
2
Power Indicator on both units will
light up when monitor is turned on.
1
2) Sound Lights
Sound lights on the Parent
Unit are activated by the
sounds of your baby. As the
sounds get louder, more
lights will illuminate.
1) Movement Indicator
Light activated by your
baby’s movement.
2
5.1 - SENSOR PAD
1 2
MOTION ALARM
• If NO movement is detected after 15 seconds you will hear a single ‘TIC’ pre-alarm
sound from the Nursery Unit.
• If after a further 5 seconds there is still NO movement detected both the Parent Unit
and Nursery Unit speakers will emit a loud warning sound.
• Green light on the Nursery Unit will turn off to indicate
NO movement is being detected.
STEP 5 - TESTING AND GETTING TO KNOW YOUR MONITOR
TO STOP THE ALARM
Place your hand
back on the
mattress. Shut the Nursery
Unit OFF
OR
1) Move your hand lightly on the mattress.
The Nursery Unit Movement
Indicator will flash continuously.
2) Remove your hand from the mattress.
After 15 seconds you will hear a ‘TIC’
pre-alarm sound, and 5 seconds later
the Movement Alarm will trigger.
3) Repeat by moving your hand lightly in
all four corners of the mattress. Ensure
the Nursery Unit Movement Indicator is
still flashing.
IF THE ALARM DOES NOT SOUND
• Avoid contact with crib while Sensor Pad is in operation.
• Place crib near a supporting wall.
• Adjust the Sensor Pad sensitivity level.
TO TEST THE SENSOR PAD:
15 14