ANSMANN 5101103 RC1 - Manual (Page 2)

GB
Operating instructiOns
use OF tHe tOrcH
The RC 1 is a rechargeable torch with krypton bulb (KR 2.2V/0.5A/P13.5).
It is powered by a 2.4V NiMH battery pack with 1,200mAh and can be
recharged direct at any 230V mains socket. The magnet allows the torch to
be stuck to any magnetic surface.
cHarging
Charge the torch before using it for the first time. To charge, remove the comple-
te bottom part of the lamp (consisting of battery pack, charging electronics and
power plug) from the slot. Connect it to a 230V mains socket. The integrated
rechargeable battery pack is then being charged with a charging current of ap-
prox. 120mA. The charging time up to the maximum charge is around 10 hours.
The battery pack can be left attached to the mains until the torch is needed. The
lamp is charged continuously to avoid losing capacity.
Operating tiMe
The operating time of the RC 1 torch is around 120 minutes.
OperatiOn
If you want to use the torch, disconnect the battery pack from the mains.
By pushing the slide switch towards the head of the lamp, the torch is
switched on. The integrated magnet at the lower part of the torch allows
the lamps to be stuck to metallic surfaces when in operation.
Attention: The bulb is sensitive to shocks. If the lamp drops, the thin
lighting filament in the bulb may break. Please recharge the lamp early
enough when in use. Never leave the lamp switched on with empty batte-
ries as this may cause damages to the battery pack.