ANSMANN 5207132 Energy 8 - Manual (Page 5)

If required the unit starts refreshing and switches over automatically to charging. As soon
as the battery is fully charged the unit switches over automatically to trickle charge. The
cells can remain in the charger always ready for use until they are needed. Under certain
circumstances the charger switches over again to refreshing during the charging process.
If the unit does not switch over to „Ready“ (battery fully charged) within 24 hours, the cell
is defective. It can no longer be regenerated and has to be replaced.
waRNiNG
In order to avoid the risk of fire and/or electric shock, the charger must be protected
against high humidity and water. In case of a defect please return the an authorised dealer.
Use only with NiCd/NiMH cells. Non rechargeable batteries or other types could cause
an explosion! Do not plug in the charger if there are any signs of damage to the housing
or power cable. Never try to open the charger. Repairs may only be made by authorised
service centres.
MaiNtENaNcE aNd clEaNiNG
To make sure that the charger works properly, please keep the contacts in the charging
slots free from dust or contamination. To clean the unit disconnect it from the mains and
use only a dry cloth.
attENtiON!
With this charger only fast rechargeable batteries, which are designed to accept the
very high charging currents used with this charger, may be inserted.
Inferior batteries could cause destruction of rechargeable batteries and the charger, if the
cells used are not suitable for fast charging.
If unsuitable cells are inserted into this charger, warranty claims cannot be accepted and
the warranty will become void.