ANSMANN 5600013 Power2go 100 - Manual (Page 4)

AtteNtION
Only use the DC-AC inverter with devices with european flat hexagon socket!
It´s not allowed to use devices with earthpin. It´s not allowed to use this DC-AC
inverter with any adaptor between inverter and electronic device.
Danger to your life!!!
INdIcAtOrs etc.
LED green „Power“ (3): Stand by
LED red „Fault“ (4) : the connected electronic equipement is over 100 W
Switch „On / Off“ (2)
OperAtION
Connect the car plug (5) to the cigarette lighter socket (12 V DC) of the car; boat,
camper etc. Ensure that the supply to the cigarette lighter socket is on. Some
vehicles require the ignition to be switched on.
Switch on the device with the switch (2). The green LED “Power” (3) shows that
the device is on. Contact the electrical equipement with max. 100 W to the DC- AC
inverter by using the European flat hexagon plug.
MAINteNANce ANd cleANING
To clean the device, disconnect it from power. Please only use dry clothes to clean
the device.
tecHNIcAl dAtA:
Input voltage: 12 V (DC)
Low battery voltage alarm: 10.7 V (+/- 0.5) V battery voltage
Low battery voltage Cut off: 10.2 V battery voltage
Output voltage: 220 V (AC)
Output power: 100 Watt
Frequency: 50 Hz
Efficiency: 85 – 90 %
Stand By current: < 0,2 A
5