Austin Hughes Fan Unit & ICM-02 - Manual (Page 9)

www.austin-hughes.com UM-ICM-02-Q215V1 P.4
Installation steps
The weight of the unit is less than 5.5 kg, so in most cases, holes in perforated cabinet doors can be used to mount the unit.
Lift the unit to the desired position.
Place attached 6 screws then through the door and tighten them.
To eliminate bypass air to maximize heat removal from the cabinet, cut the air blocking material to the size necessary with cutter or
scissors then apply the material to the inside surface of the door with screws or adhesive backing. Ensure all open perforations are
covered by the material.
Connect the power cord to the PDU of the cabinet through the cable entry hole on the rear top of the cabinet.
If no cable entry on the top, the unit may be installed on the inside but the model need to be changed. Please refer to P.2 .
Mounting
screws
Cable
clip
Power
cord
ON / OFF
Button
Perforated
Cabinet Door
Use cable clip to hold the
power cord if necessary
1
2
3
4
5
< 1.2 > 33U Door Mount Fan Panel