Lcd inverter connector (jbkl), Serial ata connectors (sata1~sata3), Usb connector (usb78) – Axiomtek MANO861 User Manual
Page 23: 9 lcd inverter connector (jbkl), 10 serial ata connectors (sata1~sata3), 11 usb connector (usb78)
MANO861 Mini ITX Board
Board and Pin Assignments
15
2.4.9
LCD Inverter Connector (JBKL)
The connector is for the control of internal LVDS brightness.
1
2.4.10
Serial ATA Connectors (SATA1~SATA3)
These connectors support SATA 2.0 and are for the Serial ATA signal cables for Serial
ATA hard disk drives.
SATA1, SATA2, SATA3
2.4.11
USB Connector (USB78)
These connectors are for USB 2.0 ports. Connect the optional USB module cable to any
of these connectors, then install the module to a slot opening at the back of the system
chassis. These USB connectors comply with USB 2.0 specification that supports up to
480 Mbps connection speed.
Pin
Signal
1
+12V
2
GND
3
BL_EN
4
BRIGHT1
5
+5V
Pin
Signal
1
GND
2
SATA_TXP2
3
SATA_TXN2
4
GND
5
SATA_RXN2
6
SATA_RXP2
7
GND
Pin Signal
Pin
Signal
1
USB+5V
2
USB+5V
3
USB-
4
USB-
5
USB+
6
USB+
7
GND
8
GND
9
NC