Lvds voltage selection (jp1 and jp2), Auto power on (jp4), Lvds brightness control mode setting (jp5) – Axiomtek PICO841 User Manual
Page 19: Restore bios optimal defaults (jp6), 1 lvds voltage selection (jp1 and jp2), 2 auto power on (jp4), 3 lvds brightness control mode setting (jp5), 4 restore bios optimal defaults (jp6)
PICO841 Intel
®
Atom
TM
Processor E3845/E3827 Pico-ITX Board
Board and Pin Assignments
13
2.4.1
LVDS Voltage Selection (JP1 and JP2)
The board supports voltage selection for flat panel displays. Use these jumpers to set
LVDS connector (CN8) pin 1~6 VCCM to +3.3V, +5V or +12V. To prevent hardware
damage, before connecting please make sure that input voltage of flat panel is correct.
JP1
JP2
2.4.2
Auto Power On (JP4)
If this jumper is enabled for power input, the system will be automatically power on
without pressing soft power button. If this jumper is disabled for power input, it is
necessary to manually press soft power button to power on the system.
2.4.3
LVDS Brightness Control Mode Setting (JP5)
This jumper enables you to select PWM or voltage control mode for inverter connector
(CN10). These two control modes are for adjusting the brightness of LVDS panel.
2.4.4
Restore BIOS Optimal Defaults (JP6)
Put jumper clip to pin 2-3 for a few seconds then move it back to pin 1-2. Doing this
procedure can restore BIOS optimal defaults.
Function
JP1 Setting
+12V level
Close
N/A
Open
Function
JP2 Setting
+3.3V level (Default)
1-2 close
+5V level
2-3 close
Function
Setting
Disable auto power on (Default)
1-2 close
Enable auto power on
2-3 close
Function
Setting
PWM mode (Default)
1-2 close
Voltage mode
3-4 close
Function
Setting
Normal (Default)
1-2 close
Restore BIOS optimal defaults
2-3 close