Bimba EF-I Repair Kits General - Manual

Bimba Manufacturing Company
Monee, IL 60449-0068
Telephone: 708.534.8544
Fax: 708.235.2014
Email: [email protected]
www.bimba.com
Form: BMS-1013
rev. 1: EC-37791
T o learn more about this
product, scan this QR code
with your mobile device.
Disassembly
1) Using snap ring pliers, remove the snap ring from the front of the cylinder. (Use extreme caution,
single acting models contain springs so the contents may be pressurized.)
2) Remove the rod guide assembly from the body. The rod guide assembly can be discarded.
3) For spring retract models, carefully remove the spring from the rod/piston assembly.
4) Remove the rod/piston assembly from the body.
5) For spring extend models, carefully remove the spring from the body.
6) Remove the piston seal from the piston. The piston seal can be discarded.
Reassembly
1) Lightly lubricate all of the new seals.
2) Install the new rod seal into the new rod guide assembly.
3) Install the new o-ring onto the outside of the new rod guide assembly.
4) Install the new piston seal onto the outside of the piston.
5) For spring retract models, install the spring back onto the rod/piston assembly.
6) Carefully install the rod guide assembly onto the rod/piston assembly. (Use extreme caution,
single acting models contain springs so the contents may be pressurized.)
7) For spring extend models, install the spring back into the piston end of the rod/piston assembly.
8) Install the piston end of the sub-assembly into the body.
9) For single acting models, the sub-assembly may need to be compressed with an arbor press.
10) Using snap ring pliers, install the snap ring back into the snap ring groove. Make sure the snap
ring is fully seated into the groove before pressurizing the cylinder.
Assembly Instructions
EF1 Repair Kits
General Repair Instructions
K-B-EF- , K-B-EFT- , K-B-EFD- , K-B-EFDT- ,
K-B-EF- -V, K-B-EFT- -V, K-B-EFD- -V, K-B-EFDT- -V