Bimba OLE - Manual (Page 5)

Table 2
Actuator Allen Key Torque
75 9/64" 12 in-lbs.
150 9/64" 12 in-lbs.
350 5/32" 35 in-lbs.
c. Mount motor to actuator, slip shaft into coupler. Secure motor to
actuator using 4 screws provided. Allen key sizes and torque values
are provided in Table 2. Be careful not to turn the coupler.
d. Tighten coupler clamp screw so motor shaft is secured (refer to
Table 1 for torque specification). The coupler clamps around the
circumference of the motor shaft. The orientation of any flat (or key-
way) on the shaft does not matter.
3
!
DO NOT screw the plug in to a hard stop. Only screw it in far
enough so that the top of the plug is flush with the outside
surface of the actuator.
!
Tighten the coupler clamp screw to the torque value in Table 1.
e. Replace the coupler access plug.
Note: Torque range is ± 10% .