Bimba Ultra Slide Rodless Cylinder - Manual

Bimba Ultran ® Slide Rodless Cylinder
Repair Instructions
CAUTION!
The magnets used in the Ultran product line are of an extremely high
strength and brittle material. Caution should be used in handling these
magnets.
If the magnets are cracked due to impact fractures during the repair
process, they will repel each other and fly apart.
During the repair of the product, be sure your fingers do not get between
the piston and the carriage. The magnets on both these parts will attract
each other and could cause injury.
NOTES
Cleanliness of the internal parts is imperative for maximum life of the slide unit. •
Parts that have been repaired should be covered or bagged until needed for •
finished assembly.
Any high grade of bearing grease should be used for lubrication purposes.
•
Tools required:
knife or wire cutters
hex driver
arbor press
screwdriver
retaining ring pliers
torque wrench
plastic bags or clean containers to hold parts during the repair
lubricant
NOTE on Arbor Press: Using an arbor press is the safest and preferred way to
perform some of the operations in these instructions. Pressing through the body’s
length is necessary, so the arbor press must have its table a distance from the floor
that is equal to or greater than the stroke of the cylinder. A proper repair is unlikely
if these warnings are not followed.