Chicago Gaming Digital Bubbler Jukebox - Manual (Page 18)

18
9. Connecting External Speakers
The Digital Bubbler supports two 8 Ohm external speakers. The speaker
terminal can be found on the back panel, next to the ethernet and phone line jacks.
To attach the speakers, run the wire from the speaker to the jukebox. Press on the
colored release tab and push the end of the corresponding wire into the terminal.
Releasing this tab will hold the wire in place.
• Be sure to connect the red terminal on the speaker to the red terminal on
the jukebox. Do not connect red to black!
• If your speaker wire is not colored, make sure you connect the same wire
to the same color on both the speaker and the jukebox
• Use only 8 ohm speakers
• Do not add more than one speaker per channel
10. AirClick
The Digital Bubbler is compatible with the Griffin AirClick. This can be
used to remotely Pause, Skip Forward, Skip Backward or adjust the volume.
Connect the AirClick to a USB port on the back panel before turning the
jukebox ON. After the jukebox boots, press Utilities to access Diagnostics. Select
AirClick Test to make sure the AirClick is functioning properly. Pressing a button
on the remote should cause its function to appear on The Digital Bubbler’s display.
Griffin AirClick USB can be purchased at
www.griffintechnology.com
The Manufacturer Part Number is 4023-ACUSB.