Cino A770 HC - Manual (Page 8)

7
Flash Mode
When flash mode is selected, the scanner flashes the light source without
having to press the trigger switch. If the scanner detects an image which is
similar to a bar code, it forces on the light source automatically and scans the
bar code.
Force Mode
When force mode is selected, the light source of the scanner is forced on for
continued operation without having to press the trigger switch. This mode is
convenient for high speed bar code reading.
Toggle Mode
When toggle mode is selected, you must press the trigger switch to turn on
the light source of the scanner to start scanning operation. The scanner
keeps the light source on until you press the trigger switch again. This mode
is very similar to alternative mode but without the preset light source on time
concern.
Diagnostic Mode
When diagnostic mode is selected, the light source of the scanner is forced
on without regard for other programmable parameters, such as reread delay,
redundancy, and so on.
Low Power Mode
When low power mode is selected, the scanner goes into idle state after
scanning the bar code. You must press the trigger switch to wake up the
scanner for operation.