Cino SM5700 - Manual (Page 82)

F
u
z
z
y
S
c
a
n
O
E
M
S
c
a
n
M
o
d
u
le
P
ro
g
ra
m
m
in
g
M
a
n
u
a
l
77
[Data Replacer]
Scan “Replacer Control” and set bar code symbology to
“48”.
Scan “1st Replacement” and set the identified position to
“00”, then replaced character to “41” (Hex Code of A).
[Data Organizer]
Scan “Organizer Control” and set bar code symbology to
“48”.
Scan “1st Organization” and set the identified position to
“16”, then set the data transmission to “0” (forward).
Scan “2nd Organization” and set the identified position to
“17”, then set the data transmission to “1” (backward).
Scan “END” (Exit) to terminate the programming.
[Important Notice]
Please note that Condensed DataWizard will follow the
preset working flow as below:
Verifier Formatter Replacer Organizer
So when you set the identified position in Data Organizer,
you must consider the inserted data which you already set
via Data Formatter.
.