Clay Paky STAGE SCAN - Manual (Page 3)

3
5
17
5
17
• Installing the projector
The projector can be installed on the ceiling or on a wall through the holes in the
bracket. It is recommended to use 2 screws ø12mm with nut and spring washer.
CAUTION: Check the plates (3 and 4) are correctly secured to the sides of the
fitting; If the plates has been removed, to carry out non-routine maintenance
work, reposition them, following the relevant instructions and checking the
threads in the projector sides hold properly.
• Securing the safety ropes
Except for when the projector is standing on the floor, it is compulsory to fit the
safety rope (17). These need to be secured to the projector framework and then
hooked onto the eyebolts (5) screwed into the sides of the projector.
INSTALLATION AND FINE-TUNING 3
• Adjusting the projector position
180
°
50
°
50
°
7
9
STAGE SCAN
• Mains power connection
It is advisable to connect each projector via its own switch so as to be able to switch
it on and off individually from a distance.
N
L
1 0 1 0 1 0
28
29
27 26
Mains
BROWN =
BLUE =
YELLOW =
GREEN =
L
N
=
• Removal of transit bands
Open up the effects compartment of the projector by lifting the relative cover (see
heading 7 MAINTENANCE) and, using the appropriate size Allen key, remove the
cover (26) from the voltage change terminal (27). Use a screwdriver to disconnect the
cable (28) from the terminal it currently occupies and reconnect to the terminal
alongside, referring to the label (29) alongside the terminal.
Having completed the operation, refit the cover (26) and close the effects
compartment.
• Changing the lens hood
Loosen the screws (24) a few turns
without removing completely, then
dislodge the standard lens hood (25) by
drawing it upwards and inwards, taking
care to avoid contact with the mirror.
Remove the wide-angle mirror head
lens hood (18) out of the projector
packing, and fit it in place of the stan-
dard hood.
Check that the lens hood is in the correct
position (slots located fully behind the
screw heads), then retighten the screws.
Verify that the lens hood produces the
required effect by selecting 100% TILT
(with dip-switch 6 off) and sliding the
PAN control from 0% to 100%.
25 24
18