Clay Paky GLOW UP STRIP 100 - Manual (Page 7)

7 GLOW UP STRIP 100
DMX Address
ADDR 001 BAT 40%
DMX C

Yy

W
Time or percent remaining
of the battery charge
Operating mode
(see page 15)
Link status
(Wireless or Wired)
Warning Radio
W42 (radio board not found)
W43 (radio board not interact)
If errors W42/W43 appear on the display,
do an RDM Discovery (see page 11) to
see if the error disappears. If it does not,
check the intactness of the wireless board.
When GLOW UP is in idle status the information page will appear on the display:
Switching on the projector - Fig. 7
The projector immediately turns on when the power cord is plugged in or, if used in battery mode, by pressing and holding down keys A and S for
several seconds.
Clay Paky GLOW UP STRIP 100 Address xxx BAT xx%
GLOW UP STRIP 100 Software release x.x x xxxxx ??? *
The control panel (Figure 8) has a display and buttons for complete programming and management of the projector menu.
The display can be in one of two conditions: idle status and settings status. When idle, the projector DMX address and percent battery charge are displayed.
If no button is pressed after a wait period (about 60 seconds) when in menu settings status, the display automatically returns to idle status. It should
be noted that when this condition occurs, any modified value that has not yet been confirmed with the
A key will be cancelled.
To turn off the GLOW UP, hold down keys A and S for several seconds. A confirmation message will appear (Switch off?).
Press A -Yes to turn off the GLOW UP or press S -NO to return to the settings menu.
7
* see pag. 7
Display symbology
Initial projector address settings
An initial address must be set on each single project for the control signal. Address settings: see page 8 or 11.
Button functions – Menu SET
• If pressed in idle status: Cyclically switches between idle status and menu settings.
• If pressed while setting a menu: Moves to an upper level without changing anything (exits the function)
Decreases the value displayed (with auto-repetitions), or passes to the next item on the menu
For quick access to the minimum parameter value, press the UP key while holding down the DOWN key.
Increases the value displayed (with auto-repetitions), or passes to the previous item on the menu
For quick access to the maximum parameter value, press the DOWN key while holding down the UP key.
Confirms the displayed value or activates the displayed function or opens the next menu.
SELECT
DOWN
UP
ENTER
Transmission to DMX cable
Reception from DMX cable
Reception DMX from Radio (wireless)
Transmission DMX from Radio (wireless)
Display symbology - (Link Status)