ClearCube CD7920-Series - Manual (Page 2)

ClearCube Technology, Inc. 3700 W Parmer Lane Austin, Texas 78727 (512) 652-3500 www.clearcube.com
G0200171 Rev A, 1.0.03.11.2015
Page 2 of 4
• Support for independently-configurable monitors
– 2 DVI monitors up to 1920 × 1200
– 1 DVI monitor up to 2560 × 1600 (requires single-
link-DVI-to-dual-link-DVI Y-cable adapter, included)
• Tera2 processors, delivering PC video, audio, and USB
over an IP network
• Integrated smart card reader (CD9924 and CD7924)
• HD audio in and out (front) and HD audio out (rear)
Client and Host Firmware Compatibility
Always use the same Teradici
®
firmware version on
PCoIP devices.
• CD9920-series and CD7920-series zero clients include
Tera2 processors, requiring Teradici firmware 4.0.3
and higher.
• Be sure that any Tera1 devices (zero client models lower
than CD9600-series and CD7600-series and any host
card models lower than V5400-series) in a deployment
use the device’s Tera1-specific firmware.
• Tera2-based zero clients do not support connection to
Tera1 quad devices.
See PC-over-IP System User’s Guide and PCoIP Firmware
Support and Compatibility Guide on the ClearCube Support
site for instructions about identifying and updating PCoIP
device firmware.
Buttons and Indicators
The list below shows indicators and front panel button
operations:
• Power Button Colors
– Green (solid): device is powered on.
– Green (blinking): PCoIP session is sleeping. Press
any key on the keyboard to wake the session.
– Orange: device is in low-power state and
wake-on-LAN (WoL) or wake-on-USB (WoUSB) is
enabled. ClearCube Sentral
® or third-party utilities
can provide WoL and WoUSB features for devices.
• Power Button Operations
– Power on: when orange, press briefly (turns green)
– Power off: press and hold for 3 seconds (turns
orange)
While in session:
• when connected to a PCoIP host card, press to
display the Zero Client Control Panel (on monitor)
with options to disconnect or power down host
device. Press the power button repeatedly to scroll
through options or to cancel.
• when connected to a VM, press to disconnect.
• PCoIP Session Indicator—shows when a connection, or
session, is established between the zero client and a host.
The link indicator displays one of the following:
– Green—a session is established between the client
and a host.
– Off—there is no session between the client and a host.
• Smart Card Reader (on supporting models only)
– Yellow-Green—smart card reader is powered on.
– Red—smart card has been reset. When red light is
flashing, the IC Card is reading or writing.
Mandatory Setup and Cooling Requirements
• Ensure at least 4 inches of space around zero client edges
and at least 2 inches of space above the zero client.
• Ambient operating temperature: 0° to 35° C
(32° to 95° F).
• Do not stack any objects on top of the zero client.