Coda Stereo Amplifier S5.5 - Manual (Page 4)

3 INITIAL SETUP
Stereo Amplifier Configuration
WARNING: Please ensure that the power switch is turned OFF while you are connecting the
amplifier. Connecting or disconnecting cables while the amplifier is powered on could cause
damage to your speakers.
Note: Ensure that the MODE switch located between the input jacks on the rear of the amplifier is
set to the STEREO position for normal operation. Bridged operation is explained on page 7.
The diagram below shows the default connections necessary to operate the AMPLIFIER S5.5 as a
stereo amplifier. This is the simplest and most common mode of operation, and the quickest way
to get started.
LEFT SPEAKER RIGHT SPEAKER
PREAMPLIFIER
AMPLIFIER S5.5
! FOR CONTINUED PROTECTION AGAINST SHOCK OR FIRE HAZARD,DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE. AC LINE INPUT SEE SERIAL T AG FOR POWER REQUIREMENTS
~ UNBALANCED INPUT RIGHT LEFT COMPACT DISC RIGHT LEFT TUNER RIGHT LEFT VIDEO RIGHT LEFT MONITOR RIGHT LEFT RIGHT LEFT IN OUT PROCESSOR RIGHT LEFT RIGHT LEFT IN OUT VIDEO RIGHT LEFT UNBALANCED OUTPUT RIGHT LEFT
T E C H N O L O G I E S I N C .
MODEL SERIAL NUMBER
VOLTAGE REQUIREMENT
MANUFACTURED IN THE USA
HZ
POWER REQUIREMENT VA
FOR CONTINUED PROTECTION
AGAINST SHOCK OR FIRE:
1. REPLACE FUSE WITH SAME
TYPE AND RATING
2. DO NOT EXPOSE THIS UNIT
TO RAIN OR MOISTURE
BRIDGED
STEREO
DO NOT ALLOW AMPLIFIER OUTPUTS
TO COMMON BETWEEN CHANNELS,
OR CONTACT CHASSIS OR INPUT GROUNDS, OR TO BE CONNECTED
TO ANY ACTIVE CURRENT SOURCE.
MAIN POWER
OFF ON
AC LINE FUSE CHART FUSE AND VOLTAGE SELECTOR
FUSE VALUE -SEE FUSE CHART VOLTAGE SELECTION- SEE OPERATION MANUAL
! NOTE
SEE SERIAL TAG FOR POWER REQUIREMENTS, REMOVE POWER CORD BEFORE CHANGING FUSE OR LINE VOLTAGE
!
12 0
AC LINE INPUT ~
TO PREVENT ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTION CAUTION
W W ARNING ARNING !
LEFT CHANNEL
UNBALANCED INPUTS
BALANCED
RIGHT CHANNEL INPUTS
UNBALANCED
BALANCED
MODE
PUSH PUSH
VOLTAGE FUSE TYPE
100V
120V
220V
240V
12 AMP SLOW BLOW 5 x 20mm
6 AMP SLOW BLOW 5 x 20mm