Digiframe DF-SCWF08w - Manual (Page 15)

15
Use as the Standalone Scanner (MicroSD Mode)
• Ensure the Scanner is switched to the “MicroSD” mode on
the side of the Scanner. (See p.10)
NOTES
1. Insert a microSD card into the card slot with the
gold contacts facing up.
2. Place the Scanner on the object with the scanning
lens facing down, making sure the scanned area is
located between the two arrows on the scanner.
3. Press the /SCAN button to start scanning, and
move the scanner slowly and steadily down towards
the bottom of the object.
* Ensure the Status LED blink green light at the normal speed.
4. Press the /SCAN button again to end scanning
and save the image to the microSD card.
* The Power LED will blink orange light.
Browse and Transfer Images
Connect computer and the Scanner with the microSD
card inside using the USB Cable. Turn on the Scanner.
You can browse the Scanner as a portable hard disk,
then transfer/copy scanned images to your computer.
* No battery is required if the Scanner is used as a portable hard disk.
ON
Press / SCAN to end.
Press / SCAN to start.