Dillon Precision RL 550 Casefeed - Manual (Page 6)

7. Remove the two rear mounting bolts and
the front right mounting bolt holding the
machine down to the strong mount or
bench.
8. Attach the CF Post Support (part #18907)
as shown in [F
IGURE
10] with the left rear
mounting screw only, finger tight only, do
not fully tighten.
9. Align the rear hole in the 550 Casefeed
Cam (part #18911) with the right rear
mounting hole in the machine frame
[F IGURE
11] and reinstall the 1/4 -20 bolt
with washer and finger tighten the nut. Pull
the plunger back and rotate the cam into
position so the front mounting hole on the
cam aligns with the front mounting hole in
frame and reinstall the 1/4 -20 bolt and
finger tighten the nut [F
IGURE
11]. We
recommend that the adjustment be
completed without a shellplate on the
platform so that the bearing on the plunger
will be allowed to bottom out on the
housing. Adjustment of the cam is as
follows: start with the cam pushed all the
way back toward the post support and pull
the operating handle down until the roller
just reaches the center of the flat on the
cam[F IGURE
12] (Hint: You can use a
powder die to support the platform in
position needed for cam adjustment – see
[F
IGURE
13]). Slide the cam forward until it
just barely touches the roller and tighten
the two mounting bolts on the cam (be
sure not to release the handle until they are
tightened). Make sure that the roller on the
plunger is centered on the cam and tighten
the mounting bolts. Cycle the operating
handle a few times and make sure the
plunger operates freely.
F
IGURE
10
F
IGURE
11
F
IGURE
12
6
7
550 Casefeed Manual, May 2007 5/22/07 8:29 AM Page 6