Ditch Witch FX20 - Manual (Page 45)

Vacuum and Pothole - 44
FX20 Operator’s Manual
Connect Hoses
CMW
Connect Hoses
1. Remove vacuum hoses from storage.
2. If potholing, remove potholing tool from storage.
3. Connect hoses. Secure all locking clamps.
4. Ensure inlet and drain valves are closed.
5. If potholing, connect water pressure hose (shown).
Start Unit
1. Insert key.
2. Choke engine if necessary. See page 20 for more information.
3. Turn key clockwise. See page 21 for more information.
4. Run engine at low throttle for 5 minutes.
EMERGENCY SHUTDOWN: Turn ignition switch to STOP.
IMPORTANT: Engine will not run at low idle when inlet valve is closed.