Ditch Witch 830 RT - Manual (Page 4)

830R/T Operator’s Manual
Overview - 3
Intended Use
CMW
Intended Use
The 830R receiver is designed to locate buried pipes and cables at an 83.0775 kHz frequency. Optional
passive power and cathodic protection frequencies (60, 120, and 180 Hz in North America; 50, 100, and
150 Hz in other locations) are available.
The 830T transmitter places a single 83.0775 kHz signal on a target cable to be detected by an 830R
receiver. The transmitter places a signal on the cable through either direct connection, inductive clamping,
or induction (broadcast) modes.
The system is designed for operation in temperatures typically experienced in earth moving and
construction work environments. Use in any other way is considered contrary to the intended use. The
830R/T system should be operated only by persons familiar with its particular characteristics and
acquainted with the relevant safety procedures. The system should be serviced only by Ditch Witch repair
centers.
About This Manual
This manual contains information for the proper use of this equipment. Cross references such as “See
page 50” will direct you to detailed procedures.
Bulleted Lists
Bulleted lists provide helpful or important information or contain procedures that do not have to be
performed in a specific order.
Numbered Lists
Numbered lists contain illustration callouts or list steps that must be performed in order.