EarthQuake CS4116 - Manual (Page 19)

Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 19
Operator's Manual
CS3814, CS3816, CS4116 Chainsaws
8. File ONLY on the “Push” stroke, do not pull the file against any
metal object as this will damage the file.
It is also important to maintain the depth gauge setting
throughout the lifespan of the saw chain. 91VG and 91P chains
use a depth setting of .025”. This setting should be checked and
corrected every third or fourth time the saw chain is sharpened.
1. Place the correct depth-gauge tool over the chain, with one
depth gauge protruding through the slot in the tool.
2. If the depth gauge extends above the slot, use a flat file to bring
the depth gauge flush with the top of the tool. Use only the
push stroke of the file. Pulling the file will damage the file.
3. Make sure to round over the leading edge of the depth
gauge to prevent kickbacks and tie strap breakage.
storage
When storing the chainsaw for periods of three months or
longer:
1. Empty and clean the fuel tank in a well-ventilated area.
2. Dispose of fuel properly. Local regulations may apply. Contact
your local government or hazardous material service for
instructions.
3. Run the engine until the carburetor is dry. This will draw the
fuel out of the carburetor, preventing costly repairs to clean
gummed fuel from the fuel system.
4. Remove the saw chain and guide bar. Clean them thoroughly
and treat with a rust preventative before storing.
5. Thoroughly clean the chain saw. Remove sawdust and
excess bar and chain oil from the clutch cover and the area
surrounding the clutch. Pay close attention when cleaning
the cylinder cooling fins and the air filter.
6. Store the unit in a dry location, out of the reach of children
and other unauthorized users.
trouBleshooting & repair
At Earthquake, we build quality and durability into the design
of our products; but no amount of careful design by us, and
careful maintenance by you, can guarantee a repair-free life
for your Earthquake Chainsaw. Most repairs will be minor, and
easily fixed by following the suggestions in the troubleshooting
guide in this section.
The guide will help you pinpoint the causes of common problems
and identify remedies.
For more complicated repairs, you may want to rely on your
retailer, an authorized service center or Earthquake. A parts
breakdown is located toward the end of this manual.
We will always be glad to answer any questions you have, or help
you find suitable assistance. To order parts or inquire about war-
ranty, call or e-mail us using the contact information found below.
ordering replacement parts
Parts can be obtained from the store where the chainsaw was
purchased or direct from the factory. To order parts visit www.
getearthquake.com or call 1-800-345-6007.
For other general questions, you can e-mail us at info@ardisam.
com.
Please include the following information with your order:
1) Part numbers
2) Part description
3) Quantity
4) Model number and serial number