EarthQuake 12802 - Manual (Page 23)

Operator's Manual
MC440 4-Cycle Cultivator
Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5 23
15073 BORDER-EDGER KIT INSTALLATION (OPTIONAL ACCESSORY)
KEY # PART # DESCRIPTION QTY.
1 15009 BORDER-EDGER TINE 1
2 46131 BORDER-EDGER WHEEL 1
3 46134 HAIRPIN 1
PARTS BREAKDOWN
The Border-Edger Kit is a useful tool for making clean cuts in
the lawn along the borders of gardens, flower beds, walkways,
and driveways for a well manicured look. To install the Border-
Edger Kit, do the following:
INSTALLATION
1. Make sure the cultivator is not running by flipping the ON/
OFF switch to the OFF position.
2. Remove the hairpins from both sides of the tine shaft.
3. Remove the cultivating tines from the shaft, remembering
which direction they are facing.
4. Put the tines in a safe place and save the (2) hairpins, they will
be used on the Border-Edger Kit.
5. Slide the border-edger tine onto either side of the tine
shaft. Make sure that the hub collar of the border-edger tine
faces outward, away from the transmission of the cultivator.
SEE FIGURE 11
6. Take the (2) hairpins saved in Step 4 and insert them through
the inner and outer holes in the tine shaft on each side of the
border-edger tine to secure the tine blade in place on the
shaft. SEE FIGURE 11
7. Slide the border-edger wheel onto the opposite side of the
tine shaft as far as it will go.
8. Insert the remaining (1) hairpin, that came with the kit,
through the inner hole next to the wheel in the middle of the
tine shaft. SEE FIGURE 11
9. Before using the Border-Edger Kit, remove the drag stake from
the unit.
10. Set the cultivator wheels to the HIGHEST (top) position.
CAUTION
BE AWARE THAT THE CULTIVATOR COULD
UNEXPECTEDLY BOUNCE UPWARD, OR JUMP
FORWARD IF THE TINES STRIKE CONCRETE,
PAVEMENT, OR OTHER HARD SURFACES OR HARD
OBSTACLES BURIED UNDER GROUND.
hairpin
border-edger
wheel
tine shaft
border-edger
tine
FIGURE 11
hub collar
KIT ASSEMBLED