Important – EarthQuake MC43E User Manual

Page 15

Advertising
background image

Operator's Manual

MC43 Series Mini-Cultivator

Check for parts online at

www.getearthquake.com or call 800-345-6007 M-F 8-5

15

Cooling Fins
Cooling fins, air inlets and linkages must be free from any debris

before each use.

air Filter
Never run engine without air cleaner properly installed. Added

wear and engine failure may occur if air cleaner is not installed

on engine.

Service air cleaner every 3 months or after 20 hours of operation.

Clean filter daily in extremely dusty conditions.

Steps for Cleaning air Filter (Ring Style Foam Filter) - See

parts breakdown section.

1. Wash in warm water with liquid detergent and water until

dirt and debris are removed. Press filter when washing, do

not twist.

2. Rinse in warm water until soap and dirt are removed.
3. Dry filter by wrapping in a clean cloth and pressing filter un-

til it is dry.

4. Apply a lightweight motor oil or thin based machine oil to

the entire filter.

5. Remove excess oil.
6. Attach the filter and air cleaner cover to the engine

.

Steps for Cleaning air Filter (Block Style Foam Filter) - See

“Parts Breakdown” section.

1. Before removing the air filter cover, move the choke lever to

the choke position. SEE FIGURE 7.

2. To remove air filter cover, squeeze the latch tabs on both sides

of the cover. SEE FIGURE 8.

3. Once the latch tabs are released, remove the air filter cover

by rotating the cover away from the engine. SEE FIGURE 9.

4. Remove the foam filter element (SEE FIGURE 10) and replace

with a new oiled filter, or clean the original foam filter with

warm water and mild soap by following the previous steps

for cleaning the air filter. Remember to thoroughly oil the

foam filter with 30 or 40 weight motor oil and squeeze out

any excess oil.

5. Reinstall the foam filter, pressing it evenly in place to ensure that

the foam is fully seated into its sealed position. SEE FIGURE 11.

6. Replace the air filter cover so that it fully snaps into place and

is secured by the latch tabs. Check that the cover is securely

attached by pulling slightly on the cover. If the cover doesn’t

move when pulled, it is secure.

Figure 7

Figure 9

Figure 11

Figure 8

Figure 10

ImPORTaNT

NEVER TWIST aIR FIlTERS WHEN ClEaNING. alWayS PRESS.

Advertising
This manual is related to the following products: