EarthQuake 6015V - Manual (Page 9)

9 Check for parts online at www.getearthquake.com or call 800-345-6007 M-F 8-5
Operator’s Manual
6015 Series CRT Rototiller
CAUTION
DO NOT TRY TO LIFT THE ROTOTILLER FROM THE
CARTON.
DO NOT ADD ENGINE OIL INTO GEAR CASE DIPSTICK
HOLE.
ASSEMBLY
Your rototiller comes fully assembled except for a few parts.
The following instructions will help you unpack your tiller and
assemble and adjust your tiller’s depth regulator lever, cable
tension and handle bar height. You will need 2- 9/16” wrenches.
Carton Contents
Rear Tine Rototiller w/Handle Bar
2 - Side Shields
2 - Wheels
Depth Regulator
Parts Bag
Tools Required for Assembly
2 - 9/16” wrenches
UNPACK
1. Open top of carton and remove handle bar assembly.
2. Find parts packet. Parts packet contains:
4 - 3/8-16 x 1-3/4” hex head bolts
2 - 3/8-16 x 1” hex head bolts
6 - 3/8-16 nylock nuts
6 - 3/8” flat washers
6 - 1/4-20 x 3/4” hex head bolts
6 - 1/4-20 nylock nuts
1 - detent pin
12 - 1/4” flat washers
2 - Handle bar extensions
CE parts packet also contains:
2 - 3/8-16 x 1” hex head bolts
2 - 3/8-16 nylock nuts
2 - 3/8” flat washers
NOTE: Parts packet also includes Engine Manual, Warranty
Registration Card and this Operator’s Manual.
3. Cut open seams of carton, exposing all contents and remove
machine by:
a. Attaching loose wheels in box onto machine with wheel
lock pins in free-wheel position. Slide wheel all the way
onto the axle and insert lock pin through the axle hole
only. (SEE OPERATION SECTION)
b. Roll tiller from carton.
L R
IMPORTANT
THE RIGHT AND LEFT SIDES OF YOUR
ROTOTILLER ARE DETERMINED FROM
THE OPERATING POSITION AS YOU FACE
THE DIRECTION OF FORWARD TRAVEL.
ENGINE IS SHIPPED FROM FACTORY
WITHOUT OIL. YOU MUST ADD ENGINE
OIL BEFORE STARTING ENGINE.
TILLER TRANSMISSION IS SHIPPED FROM
FACTORY WITH THE PROPER AMOUNT
OF GEAR LUBE.
detent pin
depth regulator
adjusting knob
FIGURE 1
INSTALL DEPTH REGULATOR
1. Locate depth regulator and detent pin. SEE FIGURE 1
2. Unscrew adjusting knob from the top of the depth regulator
and slide depth regulator up into vertical slot at the rear of the
tine shield. SEE FIGURE 1
3. Reattach the adjusting knob to the top hole of the depth
regulator.
4. Insert detent pin through the hole in the vertical slot and a
hole in the depth regulator to hold it in place.