English, Troubleshooting guide – EarthQuake MC43E User Manual

Page 17

Advertising
background image

Operator's Manual

MC43 2-Cycle Cultivator

Check for parts online at

www.getearthquake.com or call 800-345-6007 M-F 8-5

17

ENGLISH

TROUBLESHOOTING GUIDE

PROBLEM

POSSIBLE CAUSE

REMEDY/ACTION

Engine will not start

1. Power switch off

1. Flip switch to ON position

2. Spark plug wire disconnected

2. Connect spark plug wire to spark plug

3. Out of fuel

3. Refuel

4. Spark plug wet, faulty or improperly

gapped

4. Clean, replace or gap spark plug

5. Fuel line hose not positioned in bot-

tom of gas tank

5. Push fuel line down into fuel in gas tank

Engine runs rough, floods during

operation

1. Dirty air filter

1. Clean or replace air filter

2. Choke partially engaged

2. Turn off choke

3. Carburetor out of adjustment

3. Call customer service

Engine is hard to start

1. Stale fuel

1. Drain old fuel and replace with fresh. Use gas stabilizer at

end of season

2. Spark plug wire loose

2. Make sure spark wire is securely attached to spark plug

3. Dirty carburetor

3. Clean carburetor, use gas stabilizer, new gas can

4. Throttle control not held open

4. Prime unit 3 more times, then pull recoil handle

Engine misses or lacks power

1. Clogged gas tank

1. Remove and clean gas tank

2. Clogged air filter

2. Clean or replace air filter

3. Carburetor out of adjustment or bad

3. Call customer service

4. Spark plug wet, faulty or improperly

gapped

4. Clean, replace or gap spark plug

Engine runs, then quits

1. Gas cap not venting

1. Clean or replace gas cap, check vent

2. Plugged fuel filter

2. Clean or replace fuel filter

3. Carburetor out of adjustment or bad

3. Call customer service

Engine revs too high

1. Carburetor out of adjustment

1. Call customer service

Tines turn at idle

1. Idle speed too high

1. Adjust idle speed lower

2. Broken clutch spring

2. Replace spring

MODEL MC43E ONLY
Charger won’t charge

1. Battery worn out

1. Replace with new battery

2. Connectors not plugged in

2. Open battery box and connect battery connectors

Key won’t start machine

2. Battery not charged

1. Charge battery

Contact Earthquake customer service at 800-345-6007 if additional assistance is needed.

Advertising