Easyrig 5 Vario - Manual (Page 8)

8
Fig. 12
Adjust the support arm height by sliding the
entire mechanism up or down to find the correct
position. Then, tighten the four adjustment
screws with the 6mm Allen-key. Replace the
cover and tighten the cover screws.
Fig. 12B
If more adjustments is required, you can also
change the position of the 20 mm tube inside
the support arm at it´s base under the bellows.
Fig. 14
By twisting the side support arm you can
shorten or lenghten them to adjustthe amount
of weight on your hips. This will fine tune your
Easyrig vario 5 vest to a comfortable position.
Fig. 13
The Easyrig vario 5 support arm is now in the
correct position.
12
12b
13
14