Echelon ISI - Manual (Page 46)

ISI Programmer’s Guide 44
IsiEvent Value Note
isiNormal 0 The ISI engine has returned to the normal, or
idle, state for an assembly. The related
assembly is encoded in the parameter; a
parameter value of ISI_NO_ASSEMBLY
indicates that the event applies to all
assemblies.
isiRun 1 The ISI engine has been successfully started
(parameter = 1) or stopped (parameter = 0).
isiPending 2 The connection related to the assembly given
with the numerical parameter has entered the
pending state. The event means the device has
received and provisionally approved a
connection invitation, but has not yet accepted
the connection invitation. This event only
applies to a connection member. For a
connection host see isiPendingHost.
isiApproved 3 The connection related to the assembly given
with the numerical parameter changed from the
pending state to the approved state. This event
occurs when a connection invitation has been
provisionally approved and accepted. This
event only applies to a connection member. For
a connection host see isiApprovedHost.
isiImplemented 4 The connection related to the assembly given
with the numerical parameter has been
implemented. This event occurs on a
connection host after calling
IsiCreateEnrollment() or IsiExtendEnrollment()
to implement a connection and close
enrollment, and on a connection member after
receiving an enrollment confirmation message
(CSMC).
isiCancelled 5 The connection related to the assembly given
with the numerical parameter has been
cancelled by a timeout, user intervention, or
network action. An assembly number of
ISI_NO_ASSEMBLY indicates that all pending
enrollments are cancelled.
isiDeleted 6 The connection related to the assembly given
with the numerical parameter has been deleted.