Step 2: connect the ft 6000 evb evaluation boards, Step 3: connect the izot router – Echelon IzoT FT 6000 EVK User Manual
Page 2
2
5. Click Install, and complete the instruction steps.
6. If you have not previously installed and activated the OpenLNS Commissioning Tool, insert the OpenLNS
Commissioning Tool EVK Edition DVD and install that now, entering the same IzoT CT or OpenLNS CT
Activation Key that you used for the IzoT Network Services Server installation. If you previously installed
the OpenLNS Commissioning Tool Professional Edition, you can continue to use it and skip to the next
step. If you previously installed and activated the OpenLNS Commissioning Tool Standard Edition, use
the Echelon License Wizard to return the OpenLNS Commissioning Tool Standard Edition license to your
account, and re-activate using the IzoT CT or OpenLNS CT Activation Key used above. This will remove
the network limit set by the Standard Edition Activation Key.
Installing the IzoT Network Services Server on the same computer with the OpenLNS Commissioning
Tool converts the OpenLNS Commissioning Tool to an IzoT Commissioning Tool. The product names
referenced by the OpenLNS Server and the OpenLNS Commissioning Tool are not all updated to the new
IzoT names by the IzoT Network Services Server. You will see references to both sets of names in the
software and documentation.
7. Download the IzoT NodeBuilder Software from
This software requires
an IzoT NodeBuilder Serial Number that is located on the back of your OpenLNS Commissioning Tool
DVD case. Once you have inserted the serial number, you can follow the instructions in the Setup
Wizard.
See the IzoT Commissioning Tool User’s Guide and the IzoT NodeBuilder User’s Guide for details on
using the IzoT Commissioning Tool, and the IzoT NodeBuilder software, respectively.
These manuals are
available at
The IzoT NodeBuilder User’s Guide is also installed on your
computer with the NodeBuilder software.
Step 2: Connect the FT 6000 EVB Evaluation Boards
Use these steps to connect your FT 6000 EVB boards.
1. Connect the orange network connector on each FT 6000 EVB to the included network cable.
2. Connect the barrel connectors of the included power supplies into the barrel jacks on the FT 6000 EVB
Evaluation Boards. Connect the power supplies to the included power cords that are appropriate to your
region, and plug the power cords into a power outlet.
Step 3: Connect the IzoT Router
Use these steps to connect your IzoT Router. Having connected the EVBs, you should have one unused power
supply and one Ethernet cable.
1. Connect the stranded end of the network cable to the left 2 terminals of the black LON/FT terminal block
on the right, as shown in figure 3. Do not connect anything to the right terminal of the black connector on
the right (the terminal with the red
X
), and do not connect anything to the orange connector on the left.