Echelon PCLTA Network Interface - Manual (Page 11)

PCC/PCLTA Network Interfaces User's Guide 3
Configuring the PCLTA-21 Network interface
In most cases, PCLTA-21 initialization occurs automatically upon installation of the card and
subsequent power-up of the computer. Manual initialization will be required following software
installation to a directory other than c:\lonworks, or after moving the PCLTA-21 system images. To
manually load the firmware image to the PCLTA-21card after you have installed the hardware, follow
these steps:
1. Click Start on the taskbar, point to Settings, click Control Panel, and then open the L
ON W ORKS
Interfaces application.
2. Click the PCLTA-21 interface in the list view on the left side of the user interface to display the
interface's properties in the details pane in the right side.
3. The details pane lists the PCLTA-21 card’s system image and transceiver properties.
4. To change the system image used by the PCLTA-21 card, click anywhere in the NI Application
property, click the box to the right, and then browse to and select the desired system image from
the LonWorks\Images\PCLTA21 folder.
Note: For more information on configuring, testing, and diagnosing the PCLTA-21 network
interface, see the LonWorks Interfaces online help.