Echelon LonWorks Router - Manual (Page 14)

• RTR-10 Router Core Module (Model: 61000R)
A compact module used by OEMs to build L ON W ORKS routers. The RTR-
10 consists of the core electronics and firmware needed to implement a
router.
• Router 5000 (Model: 14315R)
A semiconductor product used by OEMs to build half-routers or full
routers for various L ON W ORKS channel types. The Router 5000 includes
the firmware required to implement a half-router.
• FT Router 5000 (Model: 14285R)
A semiconductor product used by OEMs to build half-routers or full
routers for L
ON
W
ORKS
Free Topology (FT) channels. The FT Router 5000
includes the firmware required to implement a half-router.
Packaged routers eliminate the need to build hardware and obtain the necessary
electrical interference and safety certifications. Thus, they allow direct, off-the-
shelf integration into the user’s L ON W ORKS network. This manual does not
describe how to use the Echelon prepackaged router products. See the Echelon
router Web page ( www.echelon.com/products/routers ) for information about the
pre-packaged Echelon router products.
This manual describes those Echelon router products that allow OEMs to design
and build their own custom routers for L ON W ORKS channels: the RTR-10 Router
Core Module, the Router 5000 chips, and the FT Router 5000 chips.
RTR-10 Overview
The RTR-10 Router Core Module is a compact module used by OEMs to design
and build L ON W ORKS routers. A L ON W ORKS router connects two communications
channels and route LonTalk messages between them. They support installation
of networks with dozens to thousands of devices.
The RTR-10 Module consists of the core electronics and firmware required to
implement a router. Its compact single inline module (SIM) form factor
minimizes the board space required to implement a router. Vertical SIM sockets
are available to minimize board space; right-angle SIM sockets are also available
to minimize component height.
A complete router, using an RTR-10 module, consists of the module, two
transceivers, and a motherboard to connect the RTR-10 router to the two
transceivers, as shown in Figure 2.
4 Introduction to LONWORKS Routers