Electrocompaniet AW400 - Manual (Page 8)

7
Warning
The amplifier will be warm.
Due to the high class A operating point used in the Electrocompaniet design,
it is normal that the amplifier feels warm. Proper ventilation will be needed,
and the amplifier should not be covered in. A good rule is to allow 1-2 inches of
air sidewise, and 2-3 inches above the amplifier.
Replacing a blown main fuse Diagram 2
Always remove the AC cord from the Inlet.
The main fuse is located in a small drawer in the AC inlet of the unit. If, for some
reason the fuse blows, turn the unit off, and remove the AC plug from the inlet.
Open the drawer with a small screwdriver and remove the broken fuse. The
spare fuse is located in the hole in front of the drawer. Push the new fuse gently
out of the hole, and place it in correct position (where the blown fuse was
removed). Push the drawer gently back to the closed position, connect the
power cord and turn the unit on.
NEVER REPLACE A BLOWN FUSE WITH OTHER VALUES THAN PRINTED
ON THE UNIT.