Electrocompaniet ECI2 User Manual
Page 7
Technical Specifications ECI 2 :
The following technical data were measured on randomised test objects and are typical
data. All measurements are made with the following equipment:
Distortion analyser:
Tektronix AA501
Oscilloscope:
Tektronix 468
Oscillator:
Tektronix SG505
Frequency counter:
Rascal 9838
Phase meter:
Hewlett Packard 3575A
Preamplifier section
Input impedance
17 kOhm
Max. input
> 14 Volt RMS
Equivalent input noise
< 3 µV
Input sensitivity for rated output
0.3 V
Amplifier section
Main voltage 120 V / 240 V. Clipping point of the amplifier is set to a level where total
harmonic distortion (THD) is 0.2 %.
Output Impedance (20 Hz - 20 kHz)
< 0,01 Ohm
Max. peak current
> 45 A
THD (measured at 1 kHz half power, 8 Ohm)
< 0,005 %
THD (measured at 1 kHz -1 dB 8 Ohm)
< 0,005 %
Rated output power
10 % change in line voltage will give app. 20 % change in output power.
8 Ohm 2 x 50 W
4 Ohm 2 x 90 W
2 Ohm 2 x 150 W
Power consumption (no load or signal)
70 W
Dimensions
Width
432 mm / 17 inches
Depth
400 mm / 15.8 inches (incl. handles)
Height
115 mm / 4.5 inches
Weight
11Kg / 24.2 lbs.
The manufacturer reserves the right to alter these specifications without further notice.