Electrocompaniet EC4.8 - Manual (Page 3)

How to connect your system
See illustration 1.
Inputs
Single- ended operation:
There are three sets of single ended inputs labelled Tape, Tuner and HT/Aux.
All inputs are similar regarding sonic performance.
Unused inputs may be shorted to ground, using a RCA shorting plug.
Balanced operation:
There are two sets of balanced inputs labelled SACD/DVD and CD.
Connect the right channel input to the inputs on the right side of the EC 4.8 and the left
channel inputs on the left side of the EC 4.8.
Outputs
REC:
Rec outputs are used for recording.
The source you listen to will be monitored through this output.
The volume control setting does not influence the record function.
Never use shorting plugs in outputs.
LINE OUT:
The line out is a variable output, dependent on the volume control setting and MUTE
function.
These outputs control the power amplifier(s).
SPAC:
These contacts are used to communicate with power amplifiers AW 2x120 and AW
3x120.
Connect a SPAC Com cable (sold separately) from SPAC A to one of the amplifier and
SPAC B to the other.
When these cables are connected to the amplifiers the EC 4.8 will monitor the vital
functions on the amplifiers.
SPAC Multi is reserved for future use.
DATA:
Connect an USB cable from the DATA port to a PC to upgrade the software on the EC
4.8.
REMOTE CHARGE:
Connect the remote ECT2 (sold separately) to this port to charge the remote.