Electrocompaniet PI 2D - Manual (Page 11)

11
ENG
Technical specifications PI 2D
The following technical data were measured on randomized test objects
and are typical data. All measurements are made at 120V / 240V //
50Hz / 60Hz
Input impedance(Single-Ended/Balanced).......................60/120 kOhm
Output impedance...........................................................< 0,03 Ohm
Noise floor (20 Hz - 20 kHz)................................................< -130 dB
Frequency response( - 3 dB)................................................1- 225 kHz
Channel separation( 1 kHz ).................................................> 120 dB
Damping factor( 8 Ohm load ) .................................................> 300
Maximum peak current.............................................................>50 A
THD+N.............................................................................< 0,005 %
Maximum sample rate/bit length....................................192kHz/24bit
SPDIF inputs: 2 x Coax, up to 192 kHz/24 bit.
2 x TOSLink, up to 96 kHz/24 bit.
USB input: 1x 192 kHz/24 bit asynchronous.
Rated output power
THD = 0,2%
8 ohm........................................ 2x100 W
4 ohm.........................................2x165 W
2 ohm.........................................2x220 W
Power consumption (no load or signal) 90 W
Dimensions
Width .....................................424 mm / 16.69 inches
Depth .....................................337 mm / 13.26 inches
Height ......................................90 mm / 3.54 inches
Weight.....................................10.3 kg. / 22.7 lbs
The manufacturer reserves the right to alter these specifications without further notice.