Electrocompaniet EMS 1 - Manual (Page 3)

3
About the EMS 1 Electrocompaniet Music Streamer
This unit is designed to work with the Electrocompaniet PD 1 DAC only.
A radio link is established between your computer and the PD 1. This link is
used to transmit music from the USB-port of your computer to the PD 1.
Unpacking the EMS 1
Immediately upon receipt of the EMS 1, inspect the carton for possible
damages during transport.
The contents of the carton
• 1 pc. Electrocompaniet EMS1
• 1 pc. USB type 2 cable.
• 2 pcs. antennas.
• 4 pc. rubber pads.
How to set up the EMS 1
1. Antennas
Screw one antenna to the antenna port on the EMS 1, tighten it with
your fingertips, no tool is necessary. Screw the other antenna to the
antenna port on the back-panel of the PD 1, labelled RF. Both antennas
should be set in an upright position and the top point should be kept
away from any close-by metallic objects.
2. USB type 2 cable
Connect the USB type 2 cable to the USB-port on the EMS 1 and to the
USB-port on your computer.
Verify that the units are set to the same channel
Both the PD 1 and the EMS 1 must be set to the same channel. From the
factory all units are set to channel 0. If you need to change the channel
this can be done by turning the channel indicators on both units, labelled
Ch. A small screwdriver can be used.
Set-up
Once connected and on the same channel the units will connect auto-
matically. The volume will automatically be set to the preset level. If a
connection is not established, or the connection is lost, the volume will
automatically be set to 0.
The EMS 1 will replace the sound card on your computer. To use EMS 1 you
must change the sound settings to make EMS 1 the preferred sound output.
You might need to restart your media player after setting up the EMS 1.
ENG