Elenco Snap Circuits® Deluxe Sound & Light Combo - Manual (Page 32)

-31-
Project 4 Light Show
+
+
+
Placement Level
Numbers
LED Attachments
All the lights in this set are LEDs - Light
Emitting Diodes. LEDs convert electrical
energy into light; the color of the light
emitted depends on the characteristics
of the material used in them.
Snap Circuits ® uses electronic blocks that snap
onto a clear plastic grid to build different
circuits. These blocks have different colors and
numbers on them so that you can easily
identify them.
Build the circuit shown above by placing all the
parts with a black 1 next to them on the board
first. Then, assemble parts marked with a 2.
Then, assemble parts marked with a 3. Then,
assemble parts marked with a 4 (just one end
of the red jumper wire, in this circuit). Install
two (2) “AA” batteries (not included) into each
of the battery holders (B1) if you have not done
so already.
If desired, place any of the LED attachments
(tower, egg, or fiber optic tree) on any of the
LEDs (red (D1), color (D8), white (D6), or the
LED on the color organ IC (U22). Note that the
fiber optic tree requires its mounting base.
Turn on slide switch (S1) and enjoy the show!
SCC-350_Manual_Part_A.qxp 7/25/14 2:40 PM Page 32