Elenco 100kHz Function Generator - Manual (Page 5)

CONTROLS
RANGE SWITCHES
Six ranges of frequency are provided by the range switch as shown in Table
1.
Table 1
SINE/TRIANGLE SWITCH
This SINE/TRIANGLE Switch selects the waveform, sine wave or triangle
wave, sent to the SINE/TRIANGLE output terminal.
FREQUENCY MULTIPLIER
The multiplier is a variable control allowing frequency settings between
fixed ranges. The ranges are as shown in Table 1.
AMPLITUDE CONTROL
The Amplitude Control provides amplitude adjustment from near 0 to 3V
or greater for both sine and triangle waveforms.
ON/OFF SWITCH
The ON/OFF Switch turns the power to the FG-500 on or off.
OUTPUT TERMINAL
The output marked SINE/TRIANGLE provides the sine and triangle
waveforms. The output marked SQUARE WAVE provides the square
wave. The output marked GND provides the ground for all output
waveforms.
POSITION TYPICAL FREQUENCY RANGE
1 1Hz - 15Hz
2 10Hz - 150Hz
3 100Hz - 1.5kHz
4 1kHz - 15kHz
5 10kHz - 150kHz
6 100kHz - 1MHz
-4-