Elenco Variable Voltage Power Supply Kit - Manual (Page 8)

r Cut the two black wires from the transformer to
1½”. Strip ¼” of insulation off of each wire.
r Feed 2” of line cord into the hole of the chassis.
Place the line cord in the slot of the strain relief and
squeeze the two sections together with pliers.
Then, insert the strain relief into the hole, as
shown in Figure J.
r Separate the two line cord wires. Place 1” of shrink
tubing over each black transformer wire. Twist and
solder the line cord wires to the black transformer
wires as shown in Figure K.
r Slide the shrink tubing up to cover the solder joints.
Shrink the tubing with the heat from your soldering
iron. BE CAREFUL NOT TO TOUCH THE SHRINK
TUBING OR WIRES WITH THE IRON.
LINE CORD ASSEMBLY
Install the following wires as shown in Figure K.
Figure J
Shrink tubing
Twist and solder
wires together
Strain relief
Pliers
Case top in this direction
FINAL ASSEMBLY
r Remove the backing from each rubber foot and
place them in the locations shown in Figure L.
r Assemble the top and bottom case sections and
fasten with four 2.8 x 8mm self-tapping screws as
shown in Figure L. Make sure the slots on the side
line up with one another.
Figure L
2.8 x 8mm Screws
2.8 x 8mm
Screws
Rubber feet
Rubber feet
Slot
Figure K
Soldering
iron
-7-
Bend wires
over as shown
Slide tubing