Elenco 030VDC @ 5A Analog - Manual (Page 4)

OPERATING INSTRUCTIONS
1. Set the AC input voltage switch on the back to the correct
setting and the correct fuse (6A - 115V, 3A - 230V) installed.
2. Set the power switch to the off position.
3. Plug the power cord into the power socket on the back of
the unit.
4. Plug the power cord into an AC output. Note: Make sure
enough space is left for heat dissipation.
5. Check that the voltage rating of the equipment does not
exceed the power supply’s rating.
Constant Voltage Mode
1. Turn the current control (coarse and fine) knobs fully
clockwise and the voltage control knobs fully counter-
clockwise.
2. Press the power ON/OFF switch to ON. The CV LED should
be lit.
3. Turn the voltage control knobs clockwise to the desired
output voltage.
4. Connect the positive and the negative output terminals to a
load or similar component.
Constant Current Mode
1. Turn the voltage control knobs (coarse and fine) fully
clockwise and the current control knobs (coarse and fine)
fully counter-clockwise.
2. Press the power ON/OFF switch to ON. The CC LED should
be lit.
3. Connect the positive and the negative output terminals to a
load or similar component.
4. Turn the current control knobs clockwise to the desired
output current value.
-3-