EMM Labs SWITCHMAN-3 - Manual (Page 9)

4. Hints and Tips
• Selecting another input (A to D), or reselecting the current input again,
immediately puts the system into Volume Control Mode, thus escaping any other
mode the system is currently in.
• When inspecting settings of a given channel, you may choose to adjust that
channel right away. Press the TRIM button at this point - the channel selection
stays the same, but now the system is in Channel Trim Mode.
• The RESET (red) button on the back of the Remote Unit restarts the Remote
only; however, the system returns to Volume Control mode at this point.
• The Remote Unit can be unplugged and plugged-in at any time. You may use this
as a sure-fire variant of System Lock feature.
Set up and adjust your system, then disconnect and hide away the Remote.
When the Remote is re-connected again, the display and LED indicators shall
update immediately. Pressing the RESET button on the back of the Remote
ensures that both units are synchronized.
• If you save the current settings (in a template of your choice,) your system set-
up survives power-down/power-up events.
9