EMP Tek Impression Series Speakers - Manual (Page 10)

Tower Speaker Outrigger Installation
Use these attractive, tower speaker outriggers for the Impression Series tower speakers to
create a wider support base for the cabinet. These outriggers make your tower speakers
more stable, and are ideal when placing them on a thickly carpeted floor.
Package contents include:
1 each small outriggers for back of cabinet
1 each large outriggers for front of cabinet
4 metal spike feet
4 metal rubber cone feet
4 each top cap nuts
4 each threaded adjustment washers
4 each machine screws
The metal spike feet work best on carpeted
surfaces. The rubber cone feet have been
included for use with wooden or tiled floors.
Attach the tower speaker outrigger plates to
the bottom of the speaker with the machine
screws provided, as shown in figure 2 below. The larger plate should be at the front of
the speaker and the smaller plate at the back of the speaker.
NOTE: To prevent scratching or damaging of the cabinet, turn the tower upside down
on a soft surface when attaching the outrigger feet.
Attach the metal spike or rubber cone feet using the top cap nuts as shown in figure 1.
Adjust the level/height using the adjustment washer above the metal spike or rubber
cone feet.
Impression Series 8 Owner’s Manual