EMP Tek E3 Series Speakers - Manual (Page 8)


Specifications
Model
Frequency Response:
Sensitivity:
Recommended Power:
Woofer(s):
Tweeter(s):
Impedance:
Crossover Frequencies:
Crossover Slope:
Dimensions: (with grille)
Grille:
Cabinet:
Weight:
E3c
Center Channel
0Hz – 20kHz
dB
10-120 Watts
(2) ” (76mm)
Aluminized Polygraphite
(1) /” (19mm) Nano-silk Dome
 Ohms
000 Hz
12dB/Octave
10-/” (27mm) W
-1/” (10mm) H
6” (12mm) D
Black Cloth
MDF/Satin Black Sand or White
.90 lbs. (2.6 Kg)
E3b
Mini-bookshelf
0Hz – 20kHz
2dB
10-100 Watts
(1) ” (76mm)
Aluminized Polygraphite
(1) /” (19mm) Nano-silk Dome
 Ohms
000 Hz
12dB/Octave
-1/” (10mm) W
6-/” (172mm) H
-1/” (10mm) D
Black Cloth
MDF/Satin Black Sand or White
.2 lbs. (1.7 Kg)
No sound from
speakers.
No sound from
one speaker.
Very little bass
and/or imaging.
Speaker wire not connected.
Speaker selector on amplifier is not on.
Balance control on receiver or pre-
amp is not centered.
Speaker wire not securely connected.
Speakers are wired out of phase.
Troubleshooting—Speakers
Probable Cause: Situation:
Make sure wire is connected at
both the speaker and the amplifier
observing proper polarity.
Activate proper selector on amplifier.
Place balance control in the center.
Check all connections at amplifier
and speakers.
Check entire system for proper
polarity and make adjustments
as necessary.
Solution: