ENMET RECON-IS - Manual (Page 5)

RECON-IS ENMET
3
2.2 RECON-IS Display
See Figure 2 for location of indications.
Indication
1 Battery Status
2 Audio Alarm status
3 Vibration status
4 Alarm type:
 HIGH, High alarm
 LOW, Low alarm
 TWA, Time weighted Average concentration
 STEL, Permissible concentration short time explosive limit
5 4 Digit with negative and point indicators
 Measurement Values
 Information Codes
6 Error alert
7 Zero Calibration
8 Calibration Point
9 Percent by Volume Measurement
Figure 2: RECON-IS Display
10 Parts Per Million Measurement
2.3 RECON-IS Button Function
Easy operation through the single button: turn on or off the detector, mute, cancel vibration alarm, information checking,
activate/deactivate confidence beep, calibration etc. In different status, the function of the button is different as follows:
Function Action
Turn on Press it for 3 seconds when it is power off.
Turn off Press it for 3 seconds when it is power on.
Cancelling sound
or vibration alarm
When alarming, press it once.
Information
checking
In normal monitoring status, press it for 1 second, the
backlit is on, and the screen displays in turns STEL, TWA,
peak level, minimum level, confidence beep information
etc.
Activate/Deactivate
Confidence Beep
When the detector is being turned on, keep pressing it till
the screen displays, “H OP” or “H CL”.
Calibration
Keep pressing it till the detector is power off and is again
turned on, the screen displays “CAL”, then release the
button, and the detector enters calibration status.
See Section 3 for more details of Button Functions.