Epifani PS Amplifiers and Cabinets - Manual (Page 8)

8
PS Amplifier Operation
Connections
WARNING! BEFORE PLUGGING YOUR UNIT IN FOR THE FIRST
TIME READ THE FOLLOWING SECTION CAREFULLY.
AC outlet voltages vary from country to country. Make sure that
the voltage in your area meets the voltage requirements printed
on the amplifier (such as AC 230V 50 Hz or AC 120V 60Hz.)
Make sure that the Voltage Selector is set in the proper position
for your area. Failure to do so could will harm your amplifier and
void the warranty.
If you change the Voltage Selector to a different voltage, you
must also change the rear-panel fuse to the proper rating as
indicated on the back of the amplifier. Failure to do so could will
harm your amplifier and void the warranty.
If you are unsure of any part of these warnings, consult a
licensed electrician or contact us at Epifani.
Powering Up
1. Verify that the power switch at the front of the amplifier is in the OFF
position. Connect the AC cable to the back of the amplifier and to a wall outlet.
2. Connect the speaker using either the Speakon jacks on the rear panel. Make
sure that you are using an "unshielded" speaker cable and that the polarity of the
cable is correct. Do not use shielded instrument cable to connect speakers.
NEVER connect plus or minus to ground. We highly recommend the use of a
Speakon to Speakon cable connection. If using a Speakon to 1⁄4” connection, be
sure the connection from the amp to cabinet is made while the amplifier is OFF.
Speakon connection wiring from the Neutrik female out of the amp is +1 and -1.
When purchasing cables, make sure the pin connection inside the connector is
+1 and -1
3. Voltage selector to the proper voltage also need to be set up with proper
fuse follow instruction in the back of the amp.for different voltage use different
Fuse value.
3. Now you can connect your instrument to the amplifier. Make certain that you