EXFO PM-1600 High-Speed Power Meter - Manual (Page 37)

Acquiring Power Measurements
High-Speed Power Meter 27
Managing the Wavelength List
To sort the list by wavelengths,
1. Press Setup to access the Setup menu.
2. Use the up/down arrow keys to select Wavelength List & Corr. Factor.
3. Press ENTER.
4. Use the left/right arrow keys to select Sort λ
.
5. Confirm by pressing ENTER. The wavelengths are sorted in ascending
order.
Note: If the list of wavelengths is full, delete a wavelength before adding a new
one. See section on deleting a wavelength on page 29.
To add a wavelength to the list,
1. Press Setup to access the Setup menu.
2. Use the up/down arrow keys to select Wavelength List & Corr. Factor.
3. Press ENTER.
4. Use the up/down arrow keys to select
λ
.
5. With λ
highlighted, use the left/right arrow keys to select Add
λ
, then
confirm by pressing ENTER. The current wavelength is displayed in the
wavelength edit box.
6. Use the left/right arrow keys to select the flashing digit of the
wavelength and the up/down keys to increase or decrease the flashing
digit. You can enter a value with a 0.01 nm resolution.
7. Confirm the new wavelength by pressing ENTER.
Note: Adding a wavelength to the list will not affect the current wavelength in
measurement mode.
Acquiring Power Measurements
High-Speed Power Meter 27
Managing the Wavelength List
To sort the list by wavelengths,
1. Press Setup to access the Setup menu.
2. Use the up/down arrow keys to select Wavelength List & Corr. Factor.
3. Press ENTER.
4. Use the left/right arrow keys to select Sort λ
.
5. Confirm by pressing ENTER. The wavelengths are sorted in ascending
order.
Note: If the list of wavelengths is full, delete a wavelength before adding a new
one. See section on deleting a wavelength on page 29.
To add a wavelength to the list,
1. Press Setup to access the Setup menu.
2. Use the up/down arrow keys to select Wavelength List & Corr. Factor.
3. Press ENTER.
4. Use the up/down arrow keys to select
λ
.
5. With λ
highlighted, use the left/right arrow keys to select Add
λ
, then
confirm by pressing ENTER. The current wavelength is displayed in the
wavelength edit box.
6. Use the left/right arrow keys to select the flashing digit of the
wavelength and the up/down keys to increase or decrease the flashing
digit. You can enter a value with a 0.01 nm resolution.
7. Confirm the new wavelength by pressing ENTER.
Note: Adding a wavelength to the list will not affect the current wavelength in
measurement mode.