EXFO IQS-8500 Series for IQS-600 - Manual (Page 90)

Creating and Starting a Test Case
76 FTB-8500 Series and FTB-8120NGE/8130NGE
EtherSAM (Y.1564) Test Case
3. Optical configuration for Ethernet 10G interface only:
3a. Select the Transceiver Mode Choices
are Local Area Network (LAN) for
regular Ethernet interface
(10.31250Gb/s) and Wide Area Network
(WAN) for Ethernet stream
encapsulated inside a SONET/SDH frame structure (9.95328Gb/s).
Choices availability depend on the unit model and options refer to
Software Options on page 380 for more information.
3b. Select the source Clock Mode (WAN transceiver mode only).
Refer to Clock Synchronization on page 385 for more information.
3c. Press Next.
3d. Enter the J0 Trace and J1 Trace
messages (WAN transceiver mode
only). Refer to WIS TX on page 243 for
more information.
3e. Press Next.
4. Port and framing
configuration:
4a. Set the
Auto-Negotiation,
Speed, Duplex, and
Flow Control
parameters. Not
available with Ethernet
10G. Refer to Interface
Setup (Ethernet) on
page 142 for more
information.
4b. Set the VLAN parameters when required. Refer to Network on
page 150 for more information.